STAMP MIX is a ready to use, one component overlay system that bonds to all clean concrete surfaces to produce a rock hard, weather proof surface. It can be troweled or stamped, stained and sealed for a beautiful, long life floor.
One 50 pound bag of Stamp Mix will require approximately 5.5 quarts (minimum 4.5 maximum 6.5) of water. For best results use a 1/2 inch drill with a Jiffy type mixing paddle. Add the measured water to a clean 5 - gallon pail. Add one EZ-Color Pak pigment pack to your measured water and mix in. With the mixer running, slowly add the Stamp Mix powder, mixing until a lump free consistency is obtained. Allow the mixed material to set, or slake for approximately 5 minutes and then re-mix prior to placement. Mix only the amount of material that can be placed within 30 minutes of mixing. Keep bagged material and mixed material out of direct sunlight for added work time. Use cold water when mixing for added working time. In cooler conditions, use warm water when mixing. Consult product technical data sheet for surface preparation and installation.